Question 1

What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

Options :

A : 1Gbps connectivity for Security Groups

B : Reserved for internal purposes. Not in use.

C : Out-of-band interfaces for access to Orchestrator itself

D : Additional ports used as uplinks

Answer: C

Question 2

What happens if the SMO Master fails?

Options :

A : The next SGM with the current lowest SGM ID assumes the role of the SMO Master.

B : The Backup SMO Master will take over in the event of a failure with the SMO Master.

C : A failover will occur on the MHO and traffic will continue to pass.

D : The Security Group will no longer pass traffic and the issue must be resolved with the SMO Master.

Answer: A

Question 3

What is the purpose of interface bonding?

Options :

A : A bond interface can be configured for high availability redundancy.

B : A bond interface is used for passing synchronization traffic between the SGMs.

C :

For load sharing which increases connection throughput above that which is possible using one physical interface.

D :

A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.

Answer: D

Question 4

Which distribution mode assigns packets to an SGM based solely on the packet destination IP?

Options :

A : User mode

B : Manual mode

C : Network mode

D : Auto-topology mode

Answer: C

Question 5

The SGM with the lowest member ID (the first one added to the security group.)

Options :

A : The MDS that pushes policy to the SMO is considered the SMO Master.

B : The first MHO configured is considered the SMO Master.

C : The SGM with the highest member ID (the last one added to the security group.)

D : What Maestro component is automatically designated the SMO Master?

Answer: D

Free 156-836 Mock Exam – Practice Online Confidently

Buying Options: