Question 1

At which stage during the high-level process of loading interval initial measurement data does Meter Data Management (MDM) normalize measurements and why?

Options :

A : Validation, Estimation, and Editing (VEE) stage, so that each interval can be compared to a specific date and time for validation.

B : Create the Final Measurements stage, so that each interval measurement is stored as a single record for a specific date and time.

C : Load the Initial Measurements stage, so that each interval measurement is stored as a single record for a specific date and time.

D : Create the Final Measurements stage, so that each interval is stored as the adjusted value to represent an average interval value.

Answer: B

Question 2

A customer is starting an Advanced Meter Infrastructure (AMI) roll-out initiative and they plan to replace their legacy scalar time-of-use (TOU) meters with smart meters. They want customer information system (CIS) to continue to bill for the same TOU periods and they do not want to change the CIS rates.In which THREE ways can you configure Meter Data Management (MDM) to support this requirement?

Options :

A : Write a custom algorithm to determine the proper rate.

B : Add an extendable lookup value containing the new device configuration type and the new usage calculation group.

C : Add the TOU mapping rule to the existing usage calculation group.

D : Add a new usage calculation group with a TOU mapping rule.

E : Set up the new usage calculation group to be identified dynamically by plug-in logic supplied on the usage subscription-s type.

Answer: A,B,C

Question 3

A small building with five metered apartments has common areas used by all residents. The common areas are metered separately, and the common usage needs to be spread evenly across residents. How should you configure the solution to bill each resident accurately?

Options :

A : Each apartment-s usage subscriptions must have two service paints, one for the apartment and one for 20% of the common areas.

B : Set up a virtual meter to include the apartment usage and 20% of the common areas.

C : Calculate the usage for each apartment by using customer information system (CIS).

D : Use a derivation algorithm to include 20% of the common areas with the apartment accounts.

Answer: B

Question 4

Initial measurement data (IMD) is imported into Meter Data Management (MDM) and can be viewed through the Measuring Component portal, but is not in the "Final" measurement status. What has the IMD passed in this case?

Options :

A : Critical validation

B : Multiplier check validation

C : Critical validation, high/low check validation, and sum check validation

D : High/low check validation

E : Sum check validation

Answer: A

Question 5

A time-of-use (TOU) template's interval size controls the values allowed as start and end times. A template can be used to generate TOU data for TOU maps whose seconds per interval (SPI) is divisible by the template's SPI. For what can you use a 60-minute template?

Options :

A : To only generate TOU data for 30-minute TOU maps.

B : To generate TOU data for 6G-, 15-, and 5-minute TOU maps.

C : To generate TOU data for 120-minute TOU maps.

D : To only generate TOU data for minute TOU maps.

E : To generate TOU data for 120-minute and 1440-minute TOU maps.

Answer: D

Free 1Z0-1091-24 Mock Exam – Practice Online Confidently

Buying Options: