Question 1

Which statement is true when SNMP access is enabled to the Session Border Controller?

Options :

A : The default community strings are acme and packet.

B : The default community stringsare public and private.

C : Community strings are in passive mode.

D : There are no default community strings.

E : Only one trap receiver can be configured.

Answer: B

Question 2

You want to prevent the Session Border Controller from generating aunique Call-ID and from modifying the dialog tags. How would you accomplish this?

Options :

A :

Navigate to the sip-interface configuration element and set the dialog-transparency parameter to disabled

B :

Navigate to the sip-config configuration element and set the dialog-mapping parameter to disabled.

C :

Navigate to the sip-config configuration element and set the call-id-transparency parameter to disabled.

D :

Navigate to the sip-config configuration element and set the dialog-transparency parameter to disabled.

E :

Navigate to the sip-config configuration element and set the dialog-transparency parameter to enabled.

Answer: E

Question 3

Which two states are needed by the active node while transitioning to standby? (Choose two.)

Options :

A : Out of service

B : Becoming-active

C : Relinquishing-standby

D : Relinquishing-active

E : Becoming-standby

Answer: B,D

Question 4

After configuring Header Manipulation Rules (HMRs) for topology hiding, your subsequent testing shows that the manipulation is not takingeffect. Identify two causes for this (Choose two.)

Options :

A :

You have not configured the out-manipulationid parameter of the sip-interface configuration element.

B : You have not enabled policy-based realm-bridging

C :

The value of the name parameter in the header-rule configuration element is different than the value of the out-manipulationid parameter in the sip-interface configuration element.

D : The value of the match-val-type parameter is not written correctly

E :

The home-proxy-address value does not matchthe $LOCAL_IP value in the new-value parameter.

Answer: A,E

Question 5

You wantto configure the maximum duration in seconds of any session in the Session Border Controller. How would you accomplish this?

Options :

A : Navigate to the media-manager configuration element and configure the max-signalingbandwidth parameter.

B :

Navigate to the media-manager configuration element and configure the flow-time-limit parameter

C :

Navigate to the sip-config configuration element and configure the operation-mode parameter.

D :

Navigate to the sip-config configuration element and configure theflow-time-limit parameter

E :

Navigate to the media-manager configuration element and configure the latching parameter.

Answer: C

Free 1Z0-404 Mock Exam – Practice Online Confidently

Buying Options: