Question 1

Refer to the exhibit.

R5 should not receive any routes originated in the EIGRP domain. Which set of configuration changes removes the EIGRP routes from the R5 routing table to fix the issue?

Options :

A : R4

route-map O2R deny 10

match tag 111

route-map O2R permit 20

!

router rip

redistribute ospf 1 route-map O2R metric 1

B : R2

route-map E20 deny 20

R4

route-map O2R deny 10

match tag 111

!

router rip

redistribute ospf 1 route-map O2R metric 1

C : R4

route-map O2R permit 10

match tag 111

route-map O2R deny 20

!

router rip

redistribute ospf 1 route-map O2R metric 1

D : R4

route-map O2R deny 10

match tag 111

!

router rip

redistribute ospf 1 route-map O2R metric 1

Answer: A

Question 2

A network administrator is reloading a router and during the bootup, he is getting the error message “%Error opening tftp://255.255.255.255/network-confg (Socket error)”. What command need to be applied on Cisco Router to fix this issue.

Options :

A : No service config

B : Write erase reload

C : Reload noconfirm

D : Copy run start

Answer: A

Question 3

Refer to the exhibit.

The administrator is trying to overwrite an existing file on the TFTP server that was previously uploaded by another router. However, the attempt to update the file fails. Which action resolves this issue?

Options :

A : Make the packages.conf file executable by all on the TFTP server

B : Make the packages.conf file writable by all on the TFTP server

C : Make sure to run the TFTP service on the TFTP server

D : Make the TFTP folder writable by all on the TFTP server

Answer: B

Question 4

Refer to the exhibit.

AS65510 iBGP is configured for directly connected neighbors. R4 cannot ping or traceroute network 192 168.100.0/24 Which action resolves this issue?

Options :

A : Configure R4 as a route reflector server and configure R1 as a route reflector client

B : Configure R1 as a route reflector server and configure R2 and R3 as route reflector clients

C : Configure R4 as a route reflector server and configure R2 and R3 as route reflector clients.

D : Configure R1 as a route reflector server and configure R4 as a route reflector client

Answer: D

Question 5

Refer to the exhibit. Jitter on the link between R101 and R201 was tested for voice traffic over port 16384 without the control communication on port 1967. Which command enables R201 to receive RTT for the configured IP SLA?

Options :

A : ip sla responder tcp-connect port 1967

B : ip sla responder udp-echo ipaddress 2.2.2.2 port 16384

C : ip sla responder udp-echo ipaddress 1.1.1.1 port 16384

D : ip sla responder auto-register 1.1.1.1

Answer: C

Free 300-410 Mock Exam – Practice Online Confidently

Buying Options: