Question 1

300-615-page127-image46

Refer to the exhibit. RBAC is configured on the MDS switch for a new SAN administrator engineer to work on

the FSPF configuration. However, after the configuration is applied the engineer who was assigned the

FSPF_Admin role cannot perform any configuration changes. Which action resolves the issue?

Options :

A :

Write rule 2 before rule 1

B : Remove rule 1 from the role

C : Configure the switch license for RBAC

D : Reload the switch

Answer: A

Question 2

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

Options :

A : Configure the NVE interfaces to be Up on both switches

B : Set a different distributed gateway virtual MAC address.

C : Set a different secondary IP addresses on NVE source-interface

D : Configure the same VNI to multicast group maping.

E : Set a different primary IP addresses on NVE source-interface.

Answer: A,D

Question 3

Refer to the exhibit. A network engineer is troubleshooting a Cisco Nexus 5000 Series Switch. The interface between the server and the switch is nonoperational and is expected to operate at 10 Gbps. The drain rate of the interface is 3 Mbps. Which action resolves the issue?

Options :

A : Configure pause error-disable recovery

B : Enable link level pause on the interface

C : Reset priority flow counters

D : Set priority flow control pause

Answer: A

Question 4

An engineer is recovering a fabric interconnect from a failed upgrade. The engineer booted the fabric interconnect to the switch(boot)# prompt and copied all the required images. Which image must be linked to nuova-sim-mgmt-nsg.O. 1.0.XXXXXXXXX1 bin to make the management image compliant with the Cisco UCS Manager?

Options :

A : Kickstart

B : System

C : UCS Manager

D : Cisco IMC

Answer: C

Question 5

300-615-page127-image8

Refer to the exhibit. A network engineer traces the packet flow from the Veth991 of a blade server toward the

core switch. The switch reports performance issues. What is the role of the interface Eth1/7?

Options :

A : IOM network interface

B : fabric interconnect uplink interface

C : IOM host interface

D : server interface

Answer: B

Free 300-615 Mock Exam – Practice Online Confidently

Buying Options: