Question 1

What is a key characteristic of the gTAA when implementing a TAS?

Options :

A : It restricts the use of off-the-shelf tools and requires custom-built components

B : It is limited to a predefined set of technologies that are specified by test automation vendors

C : It is vendor-neutral and can be implemented using any software engineering approach or tools

D : It mandates the use of specific vendor tools and technologies for test automation

Answer: C

Question 2

Which principle ensures that every component of a TAS should be in charge of exactly one thing?

Options :

A : Single Responsibility

B : Dependency Inversion

C : Replacement

D : Extension

Answer: A

Question 3

Consider a defect is found in the current release of the software.In your opinion, which of the following best explains why a defect of this nature might recur in later releases?

Options :

A : Automated re-testing of defects is ineffective in verifying that the fixed defect will function as intended in subsequent releases

B : The synchronization between multiple software archives is not properly controlled by the configuration management process

C : The automated defect re-test typically has a smaller functional scope than other automated tests

D : The automated defect re-test is not added to the automated regression test suite that will be run in future releases

Answer: B

Question 4

What is this called when the SUT gives users insight into the behavior of the system by showing them the status of the various actions taken so they can verify that the predicted behavior matches the actual behavior?

Options :

A : Observability

B : Controllability

C : Portability

D : Maintainability

Answer: A

Question 5

The test automation solution you are using has been operating for three years. One problem you've identified is the increasing number of false-positive results, which require a lot of investigation and troubleshooting work.

Whenever new scripts are developed, it seems like a few additional ones are added even if every one of them is fixed when it is discovered.

What is the most likely issue with the TAS that is causing the introduction of these false-positives?

Options :

A : The verification functions are not standardized; instead of using a standard verification technique, they are implemented specifically for each script

B : There is incompatibility between TAS and SUT error recovery techniques

C : The software is not waiting for a response from the preceding action, and the wait mechanisms are incorrect

D : The test cases and test steps overlap, which makes a change in one place break the same code that is utilized in another

Answer: A

Free CTAL-TAE_V2 Mock Exam – Practice Online Confidently

Buying Options: