Question 1

You are installing an AP to be used by 23 laptops. All laptops will connect on the 5 GHz frequency band. A neighbor network uses channels 1 and 6. What channel should be used for this AP and why?

Options :

A : A 5 GHz channel, because channels 1 and 6 are 2.4 GHz channels they have no impact on the decision

B : Channel 1, because it is best to use the channel with the lowest frequency

C : Channel 11, because channels 1 and 6 are in use nearby

D : Channel 6, because it is always best to use this channel

Answer: A

Question 2

You are performing a post-implementation validation survey. What basic tool can be used to easily locate areas of high co-channel interference?

Options :

A : Laptop-based spectrum analyzer

B : Access point spectrum analyzer

C : Throughput tester

D : Wi-Fi scanner

Answer: B

Question 3

You manage a WLAN with 100 802.11ac access points. All access points are configured to use 80 MHz channels. In a particular BSS, only 40 MHz communications are seen. What is the likely cause of this behavior?

Options :

A : All clients implement single spatial stream radios

B : The AP is improperly configured to use only 40 MHz of the 80 MHz allocated bandwidth

C : The clients are all 802.11n STAs or lower

D : The short guard interval is also enabled.

Answer: C

Question 4

Which statement correctly describes an ad hoc wireless network?

Options :

A : It is referred to as an IBSS.

B : It has a maximum connectivity range of 1000 meters.

C : It requires an AP.

D : It uses multiple wireless frequencies.

Answer: A

Question 5

The requirements for a WLAN you are installing state that it must support unidirectional delays of less than 150 ms and the signal strength at all receivers can be no lower than -67 dBm. What application is likely used that demands these requirements?

Options :

A : VoIP

B : E-Mail

C : RTLS

D : FTP

Answer: A

Free CWNA-109 Mock Exam – Practice Online Confidently

Buying Options: