Question 1

Time profiles are made out of levels, which are in turn made out of periods. What are the ways SAP IBP identifies profiles and periods?

Options :

A : Periods are identified by an integer and profiles by an alphanumeric prefix.

B : Periods are identified by an alphanumeric prefix and profiles by an integer.

C : Both periods and profiles are identified by an integer.

D : Periods are identified by a start and end date and profiles by an integer.

Answer: D

Question 2

What is an example of a commonly used time-independent key figure?

Options :

A : A Special key figure marked as an aggregate key figure (aggregate constraint)

B : A unit of measure key figure, such as UoM Conversion Factor

C : Any attribute as a key figure

D : A currency conversion key figure, such as Exchange Rate

Answer: B,C

Question 3

Which of the following configuration options are part of the new key figure creation process? Note:There are 3 correct Answers to this question.

Options :

A : Hiding or displaying totals for the key figure

B : Enabling planning notes for the key figure

C : Setting permitted planning levels

D : Setting disaggregation logic for the key figure

E : Enabling fixing for the key figure

Answer: A,B,D

Question 4

What are some of the prerequisites for configuring a planning area that results in a successful consistency check? Note: There are 2 correct Answers to this question

Options :

A : Configure at most two input key figures on the same planning level in a key figure calculation.

B : Assign the compound master data type and its component master data types.

C : Specify a planning horizon in the planning area for each level of the assigned time profile.

D : Configure at least one calculated key figure for the planning area.

Answer: B,C

Question 5

Which constraints are taken into account by the Time-Series-Based Supply Planning Heuristic (Infinite)?Note: There are 3 correct answers to this question.

Options :

A : Transportation lead times

B : Maximum lot size

C : Minimum lot size

D : Adjusted transport receipts

E : Aggregated constraints

Answer: A,B,D

Free C_IBP_2502 Mock Exam – Practice Online Confidently

Buying Options: