Question 1

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

Options :

A : Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Question 2

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority

has been configured. Which statement is true in this scenario?

Options :

A : The device with the lowest MAC address will be elected as the root bridge.

B : The device with the highest MAC address will be elected as the root bridge.

C : The device with the lowest numerical lo0 IP address will be elected as the root bridge.

D : The device with the highest numerical lo0 IP address will be elected as The bridge.

Answer: A

Question 3

Which statement is true about the BGP active state?

Options :

A : The BGP active state is the initial state where all BGP traffic is refused.

B : The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection

C : The BGP active state is when BGP waits for the TCP connection to be established.

D : The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer.

Answer: B

Question 4

Exhibit JN0-363-page37-image20 Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGPsession with the ISP?

Options :

A : A local address must be specified.

B : A local AS must be specified.

C : The BGP session type internal must be specified.

D : The BGP session type external must be specified.

Answer: A

Question 5

Which statement is true about the BGP active state?

Options :

A : The BGP active state is the initial state where all BGP traffic is refused.

B : The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection

C : The BGP active state is when BGP waits for the TCP connection to be established.

D : The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer.

Answer: B

Free JN0-363 Mock Exam – Practice Online Confidently

Buying Options: