Question 1

Digital hygrometers

Options :

A : consist of a bimetallic sensing element protected from wind gusts

B : are used to measure temperature from a distance

C : use a thermocouple in contact with the surface to measure temperature

D : determine relative humidity, air temperature, and dew point temperature

Answer: D

Question 2

When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

Options :

A : Go with the majority opinion

B : Never change his/her mind

C : Achieve consensus through negotiation

D : Call the supervisor

Answer: B

Question 3

You are the NACE Inspector on a job where NACE No.2/SSPC - SP 10 has been specified. You are finding the Contractor is leaving mill scale on the surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in compliance with the standard.

Your FIRST preferred course of action is to:

Options :

A : Review the relevant standard with the Contractor

B : Permit coating to take place so as not to lose the blast

C : Call your supervisor

D : Shut the job down

Answer: A

Question 4

A single application coating film has measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%. What wet film thickness (WFT) was applied?

Options :

A : 5 to 6 mils (125 to 150 microns)

B : 10 to 12 mils (250 to 300 microns)

C : 8 to 10 mils (200 to 250 mils)

D : 6 to 7 mils (150 to 175 microns)

Answer: D

Question 5

NACE No. 4/SSPC-SP-7 is a joint standard for

Options :

A : white metal blast cleaning

B : brush-off blast cleaning

C : commercial blast cleaning

D : near-white metal blast cleaning

Answer: B

Free NACE-CIP1-001 Mock Exam – Practice Online Confidently

Buying Options: