Question 1

(Full question statement start from here)What is one key advantage of using a sniffer profile on FortiSwitch compared to using the sniffercommand? (Choose one answer)

Options :

A : It allows packet capture on all switch ports without limitations.

B : It eliminates the need to use access control lists (ACLs) or port mirroring for analysis.

C : It automatically filters irrelevant traffic types.

D : It automatically decrypts SSL/TLS traffic for full packet inspection.

Answer: A

Question 2

You need to mirror traffic from a source port on Switch A to a monitoring device on Switch C. For thatpurpose, youre configuring Remote Switched Port Analyzer (RSPAN).1Due to the nature of RSPAN,what is the best practice when setting it up? (Choose one answer)

Options :

A : Use the same VLAN already configured for regular data traffic.

B : Use a dedicated VLAN assigned only to monitoring devices.

C : Use a dynamic VLAN that includes all switch ports.

D : Use the RSPAN VLAN as a native VLAN on all trunk ports.

Answer: B

Question 3

How is traffic routed on FortiSwitch?

Options :

A : Hardware-based routing on FortiSwitch is handled by the CPU.

B : FortiSwitch looks up the hardware routing table and then the forwarding information base (FIB).

C : ASIC hardware routing can only handle dynamic routing, if supported.

D : Layer 3 routing can be configured on FortiSwitch, while managed by FortiGate.

Answer: D

Question 4

Refer to the exhibit.You configured Switched Port Analyzer (SPAN) to monitor traffic from a source port on FortiSwitch 1,but the monitoring device is connected to FortiSwitch 2. After port mirroring configuration ontiSwitch 1, the monitoring device is not receiving any mirrored traffic.What is the most likely reason the mirrored traffic is not reaching the monitoring device? (Chooseone answer)

Options :

A : SPAN does not support forwarding mirrored traffic across multiple switches.

B : SPAN traffic must be filtered with an access control list (ACL).

C : The SPAN session must be restarted after configuration.

D : The monitoring device must use a management IP in the same subnet.

Answer: A

Question 5

Refer to the exhibit.Which two statements best describe what is displayed in the FortiLink debug output shown in theexhibit? (Choose two.)

Options :

A : FortiSwitch is sending FortiLink heartbeats to FortiGate.

B : FortiSwitch is discovered and authorized by FortiGate.

C : FortiSwitch is in a waiting state to join the stack group on FortiGate.

D : FortiSwitch is ready to push its new hostname to FortiGate.

Answer: A,B

Free NSE5_FSW_AD-7.6 Mock Exam – Practice Online Confidently

Buying Options: